![]() The wire braid shield must be largely intact for the cable to function properly. If you see a lot of little pieces of wire braid accidentally cut off during this step, start over. You know you did well when pulling off the hollow jacket piece and little to no pieces of wire braid shield came off with it! Take the cable out of the tool and pull off the two pieces as below That is the first level strip blade cutting through the wire braid shield and down to the copper conductor.Īfter the grinding stops, continue turning three more times as this will now slice into the cable jacket for the second level strip.but be careful not to accidentally overstrip on this step, as you will remove more braid shield than you want to! Once the cable is properly inserted, turn the entire tool clockwise. Put the cable end into the tool, cut-end even with the right side Here is the step by step preparation process, with pictures: Fortunately, trueCABLE has been offering a handy tool for some time that does both of these functions and also has a braid comb on it, our Cable Cutting & Stripping Tool. The tools required for the job are one for cutting your cable to length and one for performing the correct strip. Stripping to 1/2”, with a 1/4” + 1/4” dual level strip involvedĬombing back the braid shield away from the foil shield Dual Shield RG-6/U Preparationĭual shield coaxial cable is very straightforward when preparing the cable for termination. Over the dielectric is foil tape that provides 100% coverage. The 18 AWG conductor is surrounded by a non-conductive dielectric hard foam. The braid shield does double duty as an actual shield as well. The solid copper center conductor acts as one half of the communications circuit, while the aluminum braid shield functions as the other half.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |